Minimum 3 characters

TP (SER.45) - Sampling valve


The TP sampling valve is used to get representative samples from pipe lines or tanks where occasional sampling of 0-8% consistency fluids is required or for calibration of continuous measuring transmitters. The valve seat design avoids any possibility of build-up. The valve opens into the pipeline.

The body comes in two pieces, body and flange fitting, in order to facilitate installation. The flange fitting is welded to the pipe and flanged to the valve body. The exit of the valve has a friendly design. It is prepared for the installation of a flexible 1 1/4" rubber pipe and includes a bucket hanger.

-Flush port
-Pneumatic actuator

DN 25/40 mm

Working pressure:
10 bar

DIR 2014/68/EU (PED)
Fluid: Group 1 (b), 2 (Cat. I, mod. A)
DIR 2014/34/EU (ATEX) Please contact Orbinox for information and availability of categories and zones.


We use our own and third party cookies, for the analysis of user navigation. If you continue browsing, we consider that you accept the use.
You can change the settings or get more information here.